Envision H712a Manuale Utente

Envision H712a User’s ManualTABLE OF CONTENTSFOR YOUR SAFETY --------------------------------------------------1SAFETY PRECAUTIONS -------------------

9HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window.2. Press < or > to navigate through the functions. Once t

10ADJUSTING THE PICTURE The descriptions for function control LEDSMainMenuItemMain Menu IconSubMenuItemSub Menu IconDescriptionContrast Contrast from

11MainMenuItemMain Menu IconSubMenuItemSub Menu IconDescriptionYes N/AAuto Adjust the H/V Position, Focus and Clock of picture.Auto ConfigNo N/ADo not

12PLUG AND PLAYPlug & Play DDC2B FeatureThis monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It all

13TECHNICAL SUPPORT (FAQ)Problem & Question Possible SolutionPower LED is not on *Check if the Power Switch is in the ON position*Power Cord shoul

14ERROR MESSAGE & POSSIBLE SOLUTIONCABLE NOT CONNECTED :1. Check that the signal-cable is properly connected , If the connector is loose, t

15APPENDIXSPECIFICATIONSDriving system TFT Color LCDLCD Panel Size 43.2cm(17.0")Pixel pitch 0.264mm( H ) × 0.264mm( V )Video R,G,B Analog Interfa

16Switch  Auto Adjust Key < / Volume > / Volume Power Button MENUExternal Controls: Functions  Contrast Brightness Focus Clock H. Posi

17Preset Display ModesSTANDARDRESOLUTIONHORIZONTALFREQUENCYVERTICALFREQUENCYDos-mode 720 x 400 31.47kHz 70.0Hz640 × 480 31.47kHz 60.0HzVGA640 × 480

181 561011 1515 - Pin Color Display Signal CablePIN NO. DESCRIPTION PIN NO. DESCRIPTION1. Red 9. +5V2. Green 10. Detect Cable3. Blue 11. Ground4. Gr

1Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference.FCC Class B Radio Freq

2PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet baseme

3SPECIAL NOTES ON LCD MONITORSThe following symptoms are normal with LCD monitor and do not indicate a problem.NOTES Due to the nature of the fluores

4INSTALLATION INSTRUCTIONS Install Remove Figure 1 Installing and Removing the Swivel BasePOWER CORDPower So

5CONTROLS AND CONNECTORS VIDEO CABLEConnecting the D-Sub Cable: Connect one end of the 15-pin D-Sub cable to the back of the monitor and connect the

6ADJUSTING THE VIEWING ANGLE For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s an

7OPERATING INSTRUCTIONSGENERAL INSTRUCTIONSPress the power button to turn the monitor on or off. The other control buttons are located

8FRONT PANEL CONTROL Power Button / Power Indicator:Press this button to turn the monitor ON or OFF.Blue — Power On mode.Orange — Off mode. MENU / E